Snap-on Motorized Loader Manuel d'utilisateur télécharger pdf (Page 35)

3-8

Setup and Programming

AUTO CLEAR can be programmed with a 1 to 9 second delay.

Use this feature to visually note the reading before the display

clears. AUTO CLEAR with no delay stores, prints and/or clears

with no delay at the initiation of the next torque or force input.

STORE DATA must be pressed to save the last

reading that displays on the LCD after a test.

AUTO CLEAR must be selected to use AUTO

STORE and AUTO SEND.

To use the AUTO CLEAR, STORE, or SEND:

1. Press AUTO CLEAR. LCD display reads:

Figure 3-4: AUTO CLEAR, STORE, SEND Display

2. Use right and left DIGIT to position the flashing (*)

character under the function being changed. To

program:

— CLEAR, press up or down VALUE to select "man"

(manual clear), "auto" (automatic), or (delayed

automatic) from "1Sec" to "9Sec" seconds.

— STORE, press up or down VALUE to select "man"

(manual) or "auto" (automatic).

— SEND, press up or down VALUE to select "man"

(manual) or "aut" (automatic).

3. Press ENTER to return to measurements mode.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 101 102

Pas de commentaire

Snap-on Motorized Loader Manuel d'utilisateur Page 35